冷凝尾氣處理設備設計及運維都有哪些要點?
VOCs冷凝回收,特別是深冷冷凝(主要為機械壓縮式),之前大家稱之為油氣回收比較多,這是因為VOCs深冷設備主要最先運用在油氣回收行業,特別是儲罐裝車逸散氣及儲罐大小呼吸逸散氣的高濃度小風量的冷凝回收。
VOCs condensation recovery, especially deep cold condensation (mainly mechanical compression type), was previously commonly referred to as oil and gas recovery. This is because VOCs deep cold equipment was first used in the oil and gas recovery industry, especially for high concentration and low air volume condensation recovery of tank loading and tank size breathing gases.
除了實現環保達標,在經濟效益上也比較明顯,這主要是一些純?nèi)軇┑幕厥盏慕?jīng)濟價值。如今,VOCs深冷運用在化工行業的預處理越來越廣泛。VOCs冷凝回收裝置設計及運維有哪些要點值得注意?快隨優樂蜂一起來看看吧~
In addition to achieving environmental standards, there are also significant economic benefits, mainly due to the economic value of recycling some pure solvents. Nowadays, VOCs cryogenic treatment is becoming increasingly widely used in the chemical industry for pretreatment. What are the key points worth noting in the design and operation of VOCs condensation recovery equipment? Come and take a look with Youle Bee~
一、關鍵參數①預冷器運行溫度在混合氣各組分的凝固點以上,進入裝置的混合氣溫度降到4℃時,可將大部分水除去,機械制冷可使大部分VOCs 冷凝為液體而回收;若需要更低的冷溫度,可以再連接液氮制冷,從而提高VOCs 回收率。
1、 Key parameter ①: The operating temperature of the pre cooler is above the freezing point of each component in the mixed gas. When the temperature of the mixed gas entering the device drops to 4 ℃, most of the water can be removed, and mechanical refrigeration can condense most of the VOCs into liquid for recovery; If a lower cooling temperature is required, liquid nitrogen refrigeration can be connected to improve the VOCs recovery rate.
?、谶\(yùn)行過程中,應密切注意冷凝溫度。降低冷凝溫度,可以提高壓縮機制冷量,降低功率消耗,提高制冷系數。但冷凝溫度過低會影響到制冷劑的循環量,使制冷量下降。
?、?During operation, close attention should be paid to the condensation temperature. Lowering the condensation temperature can increase the cooling capacity of the compressor, reduce power consumption, and improve the refrigeration coefficient. However, a low condensation temperature can affect the circulation of refrigerant, resulting in a decrease in cooling capacity.
?、?R402a 與R402b 作為短期制冷劑能夠發揮很好的效果,而R404a 與R407a 可以作為長期使用制冷劑。
?、?R402a and R402b can perform well as short-term refrigerants, while R404a and R407a can be used as long-term refrigerants.
?、芤话銓τ谟蜌饣厥占晒に噥碚f,冷凝段溫度可控制在-40~-50℃(為了使回收裝置的排放濃度控制在很低水平)或-20~-30℃(為了使回收裝置的投資成本及能耗控制在低水平)。
④ For the integrated process of oil and gas recovery, the temperature of the condensation section can be controlled at -40 to -50 ℃ (to keep the emission concentration of the recovery device at a very low level) or -20 to -30 ℃ (to keep the investment cost and energy consumption of the recovery device at a low level).
二、其他要求控制和調整壓縮機吸氣壓力、排氣壓力、膨脹閥前的制冷劑溫度等在合理范圍內。
2、 Other requirements include controlling and adjusting the suction pressure, discharge pressure, and refrigerant temperature before the expansion valve of the compressor within a reasonable range.
如下為冷凝裝置運行維護要求:
The following are the operation and maintenance requirements for the condensing device:
冷卻器/冷凝器需要檢查其處理效果,檢查要點為:不凝性氣體收集凈化情況,相關說明:收集凈化情況差,說明污染排放多
The treatment effect of the cooler/condenser needs to be checked, with the key points being the collection and purification of non condensable gases. Relevant instructions: Poor collection and purification indicates high pollution emissions
設備內部零部件情況,檢查要點為:蒸發型冷卻器的噴嘴霧化狀況,相關說明:噴嘴霧化效果差,則冷卻效果差
The condition of internal components of the equipment, the key points for inspection are: the atomization condition of the nozzle of the evaporative cooler. Relevant instructions: If the atomization effect of the nozzle is poor, the cooling effect is poor
設備內部零部件情況,檢查要點為:開式冷卻系統的冷卻水混濁度,相關說明:冷卻水水質越混濁,冷卻效果越差
The condition of internal components of the equipment, the key points for inspection are: the turbidity of the cooling water in the open cooling system. Relevant instructions: the more turbid the cooling water quality, the worse the cooling effect
設備內部零部件情況,檢查要點為:設備內外壁,相關說明:是否有水垢積聚等現象,特別是殼管式冷凝器
The condition of internal components of the equipment, the key points for inspection are: the inner and outer walls of the equipment, relevant instructions: whether there is scale accumulation, especially for shell and tube condensers
操作參數是否正常穩定,檢查要點為:出口溫度,相關說明:出口溫度變高,冷卻/冷凝效果變差
Whether the operating parameters are normal and stable, the key points for inspection are: outlet temperature. Relevant instructions: If the outlet temperature increases, the cooling/condensing effect will deteriorate
操作參數是否正常穩定,檢查要點為:冷卻介質流量和壓力,相關說明:冷卻介質流量低、壓力低,則冷卻/冷凝效果差
Whether the operating parameters are normal and stable, the key points for inspection are: cooling medium flow rate and pressure. Relevant instructions: If the cooling medium flow rate is low and the pressure is low, the cooling/condensing effect is poor
操作參數是否正常穩定,檢查要點為:出口溫度與冷卻介質進口溫度的差值,相關說明:差值越小,說明冷卻/冷凝效果差
Whether the operating parameters are normal and stable, the key points to check are: the difference between the outlet temperature and the inlet temperature of the cooling medium. Relevant explanation: the smaller the difference, the worse the cooling/condensing effect
有機溶劑回收量,檢查要點為:冷凝器溶劑回收量,相關說明:回收量變少,冷凝效果變差/回收量變化率大,設施運行不穩定
The key points for checking the amount of organic solvent recovery are: the amount of solvent recovery in the condenser. Relevant instructions: If the amount of recovery decreases, the condensation effect will deteriorate/the rate of change in the amount of recovery will be large, and the operation of the facility will be unstable
本文由 冷凝尾氣處理設備 友情奉獻.更多有關的知識請點擊 http://wmjdwx.com/ 真誠的態度.為您提供為全面的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.
This article is a friendly contribution from condensing exhaust gas treatment equipment For more related knowledge, please click http://wmjdwx.com/ Sincere attitude To provide you with comprehensive services We will gradually contribute more relevant knowledge to everyone Coming soon.
地址:山東省菏澤市成武縣經濟開發區機電產業園鋼架結構單層5號
【微信二維碼】
留言咨詢Adopting different technology and process control schemes
魯公網安備 337172302372103號